IE Cold Air Intake

The IE Cold Air Intake replaces your restrictive stock box with a high-flow, ram-air-inspired system that delivers up to +10-20 hp and torqueon tuned setups. Expect snappier throttle response, a deeper induction growl, and a stylish upgrade under the hood.

Designed using advanced CAD and 3D scanning, this intake uses a three-piece heat shield, velocity stack, and 55-inch inlet to channel cool air straight to the turbo all with a perfect fit into your factory mounts.

The triple-layer heat shield pulls cold air from the front of the bumper while isolating the intake from engine and turbo heat. A second heat shield sits above the turbo for added thermal protection. The velocity stack ensures air enters the system with minimal turbulence for maximum flow.

No trimming, no modifications. Uses OEM rubber grommets and mounting locations for a hassle-free install that takes about an hour with basic tools.

Tested on a fully built Stage 2 B9 A4 2.0T on IE's Dynapack hub dyno, the only charge was the intake swap. Results: solid peak gains in both horsepower and torque.